Can You Put Pavers On A Slope?
Can You Put Pavers On A Slope?
Yes, you can put pavers on a slope. Putting pavers on a slope resembles installing pavers on flat ground for the most part.
In terms of prepping the ground and the procedures necessary for a successful installation, the process is practically identical. Here’s how to install it on a slope:
Step 1: Lay The Pavers.
When putting pavers on a slope, this stage will take longer than when installing them on a flat surface. However, your patience will be rewarded because a good installation will prevent tripping risks and an ugly final job.
Begin putting down your paving stones at the bottom of your route, following your selected design. Begin with the pavers in the walkway’s center and work your way out to the borders.
Work your way from the bottom of the path to the top of the path in the same fashion.
As you make your way up the route, cut the pavers using concrete blades on your circular saw to fit the grade of the slope.
For example, to allow your installation to slowly rise with the slope while keeping the walking surface equal, you may need to make your pavers smaller.
Step 2: Add A Border.
It is critical to building a border to assist preserve the longevity of your investment. This can be a wood or plastic landscaping border, or a paving stone border, which requires more labor but looks much nicer.
Step 3: Finish With Joint Sand.
Fill the joints between the pavers by pouring joint sand over your installation. Tamp the sand down with your tamper or plate compactor, making careful to use a pad to avoid damaging the paving stones.
Remove any excess sand from the pavers with your push broom. Then, wet down all of the paving stones and sand with your yard hose.
Step 4: Seal The Pavers.
Even though this step is optional. It is recommended that you seal your pavers once you have finished placing them to protect them and keep them looking good over time.
A sealer is especially important on a slope since the water will be moving down the slope at a rapid pace and will most likely wash out all of the joint sand over time. The sealer aids in the retention of the joint sand.
Does Sealing Pavers Make Them Slippery?
Yes, sealing pavers can make them slippery if the sealer is applied too thick, as this can leave a slick film on the surface. To avoid this, it is best to use a thin mil sealer that penetrates deep into the surface, leaving only a very thin film on the top.
You can also use additives in the sealer to increase the friction on the surface. Another option is to use a penetrating sealer, which soaks into the sub-surface without leaving a slippery film behind.
A common concern with pavers is that they may become slippery when wet. However, this is not necessarily the case, as the type of sealer used can affect the slip resistance of the surface. A sealer that is designed to enhance the slip resistance of the pavers can actually make them less slippery when wet.
