Do Concrete Slabs Need Piers?

Do Concrete Slabs Need Piers?

Do Concrete Slabs Need Piers?

Yes, Concrete slabs usually need piers to support them and keep them level. The primary reason for employing slab piers is to level your property. If you’ve observed your home settling, whether it’s slanting to one side or sinking evenly over the entire structure, you’ll need a technique to raise it back up. This is where slab piers come into play, making it considerably easier to level the existing foundation.

Piers are a form of underpinning that is only utilized on constructions with slab foundations. Underpinning is a process that involves reinforcing the existing foundation and strengthening the underlying soil by extending the foundation so that the load above is evenly distributed over a larger surface. It is used to bolster and support a home or building that is experiencing foundation settlement.

These galvanized steel piers are installed past problematic land and pushed deep into supportive soil to permanently stabilize your property and bring the concrete slab back to its original level position.

Slab Piers provide a long-term solution with little mess and stress, as well as the ability to repair cracks and gaps and remove tripping hazards.

Do Rats Burrow Under Concrete Slabs?

Yes, rats are known to burrow under concrete slabs in order to create their own little homes. If you see holes around your foundation or beneath rocks, it’s likely that you have rats on your property.

While you might not think that a rat would be able to burrow through concrete, they are actually quite adept at doing so. In their burrows, they create cozy little nests where they can sleep and raise their young.

Rats can get beneath anything to build a nest, forage for food, or hide from predators. Rats burrow in dark nooks away from humans, including subterranean locations in the building’s foundation.

They will dig beneath the slabs when excavating inside the building structures. Rats burrowing in concrete slabs can cause a gap in the foundation, resulting in fractures

How Do You Remove Black Spots From Concrete Slabs?

Layers of filth and oil, chemicals, ink, or other things make up black stains on concrete. As dirt layers gather on top of the stain, the mix of components darkens.

When removing a black stain from concrete, it is critical to remove all of the stain’s layers in order to prevent additional dirt and debris from adhering to the stain’s top layer.

A water-based method can remove a black stain from concrete without the cost of a professional remedy. Ammonia solutions can be used;

Step 1.

Using a brush, sweep the concrete to remove any loose dust and grime. Sweep the debris onto a dust pan and place it in a garbage bag or can.

Step 2.

In a bucket, combine 1 cup of ammonia and 1/2 gallon of warm water. To keep your hands dry, put on latex gloves. Using a soft-bristled scrub brush or sponge, stir the mixture.

Step 3.

Apply the mixture to the black stain and leave it for 5 minutes to dry. Scrub the black stain thoroughly using a brush or sponge to remove the stain’s top layer. Reapply the mixture to the stain and scrape it away until the stain is gone.

Step 4.

Soak an old towel or a store towel in warm water from the sink. With a moist cloth, thoroughly clean the area where the stain was. Allow the concrete to dry naturally.

Related Posts

error: Content is protected !!