Does Gorilla Epoxy Work On Granite?
Does Gorilla Epoxy Work On Granite?
Yes, Gorilla epoxy works fine on granite. Gorilla Epoxy is a strong, durable sealant that will work on granite surfaces and fill gaps up to 1/16th of an inch.
It is formulated to resist weathering and fading and is suitable for indoor and outdoor use. However, you need to ensure that the surface you are working on is clean, dry, and free of grease.
Epoxy is a type of sealant that needs to cure before it can be sanded. Gorilla Epoxy must be applied in a thin layer with a foam roller. It would be best if you also let it cure for fourteen days before sanding.
One of the most important things to consider when using epoxy on granite is surface preparation. Ensure the surface is clean and free of oil, wax, or other contaminants. Then, roughen the surface with coarse sandpaper before applying the epoxy.
Once the epoxy is applied, allow it to dry completely before beginning the sealant application. Apply a thin layer of epoxy to the surface using a spreading motion. Work the epoxy into the gaps and edges of the granite, letting it dry for several hours.
After the epoxy has fully cured, re-coat the surface with another thin layer if needed, be sure to sand the sealant smoothly before applying the final coat of epoxy.
How Do You Epoxy Granite Seams?
Epoxying granite seams can be frustrating, but it can be easily done with the help of a few simple tools and techniques. First, tape around both sides of the seam to prevent the epoxy from smearing on the stone or any other surface or object.
Then, mix the epoxy for about a minute until it is completely smooth and free of air bubbles. Using a foam brush, paint the epoxy into the seam from one side to another in an even layer. Be sure to apply enough so that it is approximately 1/8″ thick. Allow it to dry for at least 4 hours.
Next, apply a second layer, but this time apply several thin coats. This will be applied from the other side of the seam to prevent it from clumping on top of itself. Leave it to dry for another 4 hours.
After the final coat has completely dried, sand lightly and smooth over the epoxide sealing once again to ensure an even flawless sealant application.
Finally, using a fine razor blade, scrape off the excess. Epoxy is a strong and durable adhesive, and you can successfully epoxy granite seams with a little effort.
Does Epoxy Ruin Granite?
No. Epoxy is a strong and durable sealant that will not ruin granite surfaces. However, epoxy cannot be placed on porous surfaces such as sandstone, marble, or limestone.
If you apply epoxy on granite, ensure that it is perfectly prepared for the job. Use oil- and grease-free mineral spirits to clean the surface of the granite with a lint-free cloth.
However, this must be done to ensure the epoxy’s proper application. Apply a thin layer of epoxy with a foam brush and allow it to dry for at least four hours before putting any weight on it.
This will work best if you use a non-sanded grout line thinner or marble bonder, which will make the line less visible while still filling the gaps between pieces of granite. Finally, it would be best if you used a non-sanded grout filler with a sanded grout filling in order to fill the gaps and seal corners between pieces of granite.
Additionally, the use of an orbital sander can do the job quickly; for a large-area project, you may choose to use a power sander. After the surface is roughened, wipe it clean with paper towels or rags. If residue is left on the surface you are working on; it can ruin your epoxy job.