Does Tabletop Epoxy Scratch Easily?
Does Tabletop Epoxy Scratch Easily?
No, tabletop epoxy does not scratch easily. It is a strong material that can withstand a significant amount of force without showing signs of damage. The only way tabletop epoxy will scratch is if you’re using something very hard to scrape the surface, like a knife.
However, if you find that your tabletop epoxy is getting scratched frequently, it means it’s time for repair! Scratches can weaken the base of your epoxy and cause it to crack or chip off your tabletop.
Even if your tabletop epoxy doesn’t show visible scratches, it is important to repair any scratches or nicks as soon as possible before they become larger problems that affect the overall integrity of the product.
Pro Marine Supplies Table Top Epoxy is a countertop material known for being resilient and durable. However, it is still possible to scratch the surface of epoxy with sharp or rough edges. In most cases, scratches on epoxy are not very noticeable.
However, using a cutting board when preparing food on an epoxy countertop is still recommended, just as you would with any other countertop. In addition, scratches on epoxy can also make it more difficult to clean.
How Do I Make My Epoxy Tabletop Shiny?
To achieve a shiny epoxy tabletop finish, start by using a microfiber cloth. Gently wipe down the surface of the epoxy, taking care to remove any dirt or debris. Once the surface is clean, apply a small amount of polish or wax and buff it into the epoxy using a circular motion. Continue until the desired shine is achieved.
First, start by mixing a single batch of tabletop epoxy in order to gauge the amount of coverage we would get with just that amount. If necessary, we can always mix up another batch. However, we feel the initial batch should be sufficient for our needs.
Next, we need to determine how much polyester fiber to add. We will be mixing our batch by a ratio of 1:1, so the amount we need to find is half of what we started with.
Polyester fiber is very light in weight and fluffy, so it tends not to weigh down the epoxy. We believe 2 ounces of polyester fiber should be adequate for our needs. Next, we will add 3 ounces of hardener into our batch, which will allow us a total of about 3 hours for complete curing time.
This is ample time for us to finish working with this batch in one day. Once the epoxy has completely cured and the polyester fiber has fully dissolved, we can now start to create the beautiful shine we are looking for.
By adding a few drops of dishwashing liquid into our epoxy, we can easily create a nice luster in just a few minutes. The mixture should be fairly thick so that it will hold its form as it is transferred to a cloth to apply.
The most important step is not to add anything that might interfere with the chemical reaction process while curing. Finally, we will add a few drops of dishwashing liquid into our epoxy, which will act as a mild surfactant to help remove bubbles and increase the final shine.
We will apply a thin layer around the edges and the floor’s lines to free the air bubble. This process can also be used for other surfaces, such as countertops.
However, after applying luster on top of it with polish, it is best to apply one coat of Pro Marine Supplies’ Epoxy Floor Finish instead. This