How Do You Attach Lattice To Concrete Blocks?

How Do You Attach Lattice To Concrete Blocks?

How Do You Attach Lattice To Concrete Blocks?

Here are steps on how to attach lattice to concrete blocks:

  1. Drill three 3/16-inch pilot holes through the ends of each trellis panel.
  2. Place the trellis panel against the concrete wall, approximately 8 inches from the ground. Using a 4-foot-long level, check for level.
  3. Bore holes through the pilot holes in the trellis and into the concrete wall using a hammer drill and 3/16-inch-diameter masonry bit.
  4. Use 2-inch masonry screws and steel washers to secure the wood trellis to the wall. Using a cordless drill or impact driver, push the screws into the concrete.
  5. Continue with the remaining trellis panels.
  6. Dig holes along the base of the wall for the climbing vines. Make each hole two to three times the diameter of the container.
  7. Remove the vine from its pot and use a three-tone claw to remove the roots.
  8. Insert the vine into the hole, tucking it back toward the trellis.
  9. Mix one handful of super-phosphate and one handful of starting fertilizer into the whole topsoil.
  10. Fill in around the vine with the improved dirt.

11 Plant the remaining vines in the same manner.

  1. Weave the long vine stems between the trellises and secure them with jute string.
  2. Throughout the summer, properly water the vines once a week.
  3. Cover the vines with a 2-inch layer of pine bark mulch.

Can You Upgrade Concrete Blocks 7 Days to Die?

Yes, you can upgrade the concrete blocks seven days to die, but it may be best for your project if you follow our building and safety guidelines.

Using any building equipment, a Reinforced Concrete block may be converted to a Steel Blocks block by adding ten (10) Forged Steel.

It is important that the holes are drilled in the correct location and that all of the other dimensions of the blocks are the same as the original.

Can You Use Concrete Blocks For A BBQ?

Yes, concrete blocks can be used for a BBQ. The BBQ block is a simple and affordable way to construct an outdoor campfire or barbecue. A typical fire-pit is 2-3 rows high, thus, each row takes seven pieces. You may add a cooking surface by purchasing the optional barbecue grill.

The charcoal color is available for the BBQ block. Charcoal is a popular color. You may purchase the optional concrete firebox kit, which includes a concrete firebox liner. All of these products can be purchased online at www.Concrete-Blocks-More.com.

How Do You Build A Square Fire Pit With Concrete Blocks?

Building a square fire pit with concrete blocks is a great way to add extra warmth to your outdoor space. You can do it with concrete blocks. Here’s how:

  1. Arrange blocks in a ring, adjusting each, so corners touch. Holes in the blocks should face the sky. If you want, turn one block every three feet to create a draw hole for airflow to the fire.
  2. Let the blocks dry for a few days before using them.
  3. Make sure the fire is completely extinguished before using the pit. Otherwise, you may end up with a burnt fire pit.

Related Posts

error: Content is protected !!
0

Compare