How Do You Calculate Roof Sheathing?
How Do You Calculate Roof Sheathing?
In order to calculate roof sheathing, divide the total roof area by 32 to determine the number of sheets required to cover the roof. A normal 4-foot by 8-foot piece of plywood covers 32 square feet.
If your roof is 1,600 square feet, divide 1,600 by 32 to get the number of sheets needed to cover the roof.
How Far Should Roof Sheathing Overhang Rafter Tails Be?
Roof sheathing should overhang rafter tails by 45-3/4 inch measurement from the cut end of the truss tail and draw a line along the trusses.
This is the upper edge of the first row of roof sheathing, with enough overhang to allow the sub fascia and fascia to tuck neatly beneath when the time comes.
It is advisable to drill pilot holes in the girts and fasten them through the roof sheathing and into the roof supports for strength.
Are H-Clips Required For 5/8 Roof Sheathing?
Panels 5/8″ thick with a span rating of 40/20 can have an unsupported edge up to 32″. This implies that roofing panels 1/2″ and 5/8″ thick are supported by roof construction (rafters or trusses) positioned at the normal 16″ or 24″ o.c. do not require edge support (H-clips).
It is also recommended to fasten plywood girts at each rafter and truss intersection to help pull the sheathing tight and to resist racking.
How Much Does Roof Sheathing Cost?
The cost of each sheet of plywood may vary based on how much the roofing firm charges for labor, so you should budget between $70 and $100.
It should also be calculated in the cost of any additional materials and equipment required to complete the installation, such as fasteners, staples, coverings, brads, shingles, or sealants.
Do You Need Sheathing Under A Metal Roof?
Yes, you need sheathing under a metal roof. Most metal roofing firms recommend that you apply felt paper on the roof sheathing before installing the metal roofing. The felt paper seals air leaks and keeps moisture out of the structure.
Can You Use Tongue And Groove For Roof Sheathing?
Yes, you may use tongue and groove for roof sheathing. It is simple to install but requires a bit more care. You have to be aware of the direction of the wood grain in the wood species that you are using for the sheathing.
If you use a wood species that shows a lot of knots, it will be impossible to follow the lines with your tongue and groove cuts.
Can You Use Metal Flashing With Plywood Sheathing?
Yes, you can use metal flashing with plywood sheathing. T&G roof decking appears elegant and luxurious.
T&G boards are most commonly employed when the sheathing is visible from the inside, such as in cathedral ceilings or certain cabin-style homes, especially if the rafters span more than 2 feet. It is your choice whether or not to use metal flashing underneath, but it is recommended.