Is Broom Finish Concrete Slippery?

Is Broom Finish Concrete Slippery?

Is Broom Finish Concrete Slippery?

No, Broom finish concrete is an excellent surface for foot traffic and is much less slippery than untreated concrete. Broom finishes are the ideal way to make a concrete surface slip-resistant.

Slipperiness of Broom finish concrete is often a result of the surface becoming wet, and it can be avoided by using a slip-resistant sealant or coating.

The use of brushed and broom finishes on concrete started as a practical matter. Contractors wanted a means to “put a bite” on smooth concrete to make driveways, pool decks, and other surfaces less slippery.

These finish options, while similar in some aspects differ greatly. For example, weathering and foot activity wear down the texture of a Broom Finish, making it more slippery than when it was first to put.

This makes the finish, particularly a light broom finish, unsuitable for pool decks. A Broom Finish on a pool deck would demand a more thorough brushing.

Deep Broom Finishes include jagged concrete peaks that are uncomfortable to walk on barefoot.

A Sand Finish, especially Sandscape, on the other hand, retains its non-slip texture over time while remaining walkable.

How do You Create Broom Finish Concrete?

The broom finish on concrete is achieved by dragging a broom across the surface of the wet concrete to create ridges.

This type of finish is commonly used on sidewalks, patios, and driveways. Broom finishing concrete is a relatively simple process, but there are a few things to keep in mind to achieve the best results.

First, the concrete must be properly mixed and poured to a consistent depth. The surface should be level and smooth before starting to broom. Second, the broom must be dragged across the concrete while it is still wet.

If the concrete begins to dry before you are finished, it will be difficult to achieve an even finish. Once you have finished brooming the concrete, it is important to allow it to dry. Concrete must cure before being walked on.

After the concrete has cured and is dry, it can be sealed to protect the concrete from water damage and to create a slip-resistant surface.

A concrete broom finish creates a rough texture that is unsuitable for bare feet. This finish is typically used for driveways or sidewalks where vehicle tires cover the texture, but this finish is very uncomfortable for barefoot walking.

How Do You Know When To Finish A Broom On Concrete?

When it comes to brooming, time is everything—brush too early, and the surface will be weak; brush too late, and there will be insufficient texture. It must be performed when the slab is still soft but after the bleed water has evaporated.

When it comes to knowing when to finish a broom on concrete, there are a few key things to keep in mind. First and foremost, you’ll want to make sure that the concrete is completely dry before attempting to finish it.

If there are any wet spots, you’ll need to let them dry completely before moving on. Once the concrete is dry, you’ll want to start by sweeping it with a stiff broom to remove any loose debris.

After that, you’ll need to use a concrete finishing trowel to smooth the surface. Once you’re finished, you’ll need to allow the concrete to cure for at least 20 minutes before walking on it.

Related Posts

Compare

Share via
Copy link