What Is A Monolithic Concrete Wall?
What Is A Monolithic Concrete Wall?
A monolithic concrete wall is a construction method that uses a single, large concrete slab as the foundation for the wall. This slab is poured all at once, and the thicker areas under the load-bearing walls and the perimeter edges take the place of footers.
Because this slab is poured all at once, it is much faster and cheaper than traditional construction methods, which can take weeks or even months to complete.
There are many benefits to using a monolithic concrete wall. For one, it’s fast and easy to build. You can complete a monolithic concrete wall in just a few days, compared to the weeks or months it can take with traditional construction methods.
And because monolithic concrete walls are so fast and easy to build, labor costs are low. This makes them a good choice for projects that need to be completed quickly and cheaply.
Another benefit of monolithic concrete walls is their durability. Because the slab is poured all at once, there are no individual pieces that can break or deteriorate.
This means that monolithic concrete walls are resistant to damage from weather and other elements, making them a good choice for high-traffic areas or buildings in frequent use.
Talk to a qualified construction contractor if you’re considering building a monolithic concrete wall. They can help you decide if monolithic concrete walls are the right choice for your project and provide you with all the information you need to get started.
How Do I Extend Concrete Walls?
Many homes and buildings are constructed in stages. The first phase includes a whole building; subsequent stages are meant to grow on this foundation.
Once your expansion’s base is in place, you may need to know how to extend the concrete walls from your old structure into your new concrete walls.
This method is subject to tight inspection rules, therefore, it is critical that you carefully follow all of the processes.
Step 1
Measure and note where you will need to drill to dowel out from your current wall. Dowelling refers to the process of epoxying rebar into an existing wall to connect the old and new walls.
There are a few rules to follow when selecting where to position your dowels. Specific measurements are marked on a blueprint if you have one.
If you don’t have a plan, take these steps: 6 foot walls “All other thicknesses require two dowels per horizontal tie-in; you must have the same number of dowels as there are horizontal bars in the current wall; and finally, your dowels must match the size of the rebar to be installed in the new wall.
Step 2
Drill 6″ in depth for each hole unless there is a different depth measurement in your blueprint or local building code.
Make sure your hammer drill has a concrete bit rather than a masonry bit. A masonry bit will be ineffective.
Step 3
Using a drinking straw, blow away all of the dust from each hole. Exhale hard while holding one end in your mouth and the other in the hole. When doing this, make sure to use protective eyewear.
Step 4
Load your concrete epoxy into your epoxy cannon according to the system’s directions. Insert the epoxy gun tip into one of the holes and pull the trigger.
Once the hole is filled with epoxy, insert one of your rebar dowels.
Insert the dowel as far as it will go, and then move on to the next hole. Do this until all the dowels are in place.
Step 5
Construct or install the rebar wall for your new concrete wall. Follow your plans to the letter.
Step 6
Using a hammer and concrete nails, attach a 2×4 to each face of the existing concrete wall at the edge.
Nail the beginning of your wall form system to these 2x4s. You may now build the rest of your new wall forms by following the directions and processes for your unique wall system.
Once that is done, and the wall is suitably braced, pour the concrete and finish the wall as you would any other.